5L LEYLAND TRUGUARD EXTERIOR SMOOTH MASONRY PAINT PALE BEIGE

5 Litre Leyland Truguard Smooth Masonry Paint Pale Beige.

A smooth, durable coating, which maintains and enhances the original texture of the underlying surface.Suitable for most exterior masonry surfaces, offering excellent resistance to the accumulation
of dirt, protecting against weathering and atmospheric pollution.The
anti-carbonation properties also resist the ingress of carbon dioxide from car exhaust fumes and prevent deterioration of concrete and steel.

Type of substrate - Concrete, cement rendering, brick, stone,
blockwork and pebbledash.
Colour availability - Brilliant White and a range of ready mixed
colours (10ltr and 5ltr). Thousands of tinted
colours also available (10ltr and 5ltr).
Finish - Matt

Coverage - 1 litre will cover approximately 10 square metres on smooth surfaces. In common with allwall paints, the spreading rate will be reduced on rough and absorbent surfaces such as pebbledash. When using more than one tin of a colour, it is advised that you intermix the
quantity required beforehand.
Drying time - Touch dry in 1-2 hours.
Recoatable after 4-6 hours.
Transportation and
storage
To avoid the risk of spillage, always store and
transport in a secure upright position.
Protect from frost.

Preparation
Ensure surface to be painted is sound, clean, dry and free from grease. Treat any mould or lichen with Sterilisation Wash as directed.
Truguard Smooth Masonry can be applied directly over bare and previously painted surfaces provided these are clean, sound and firm. Chalky, underbound surfaces should be scraped, dry brushed and then given a coat of Truguard Stabilising Masonry Primer. Remove any limewash or distemper completely. Wear a suitable face mask if creating dust. Before applying Truguard Stabilising Masonry Primer to the whole surface, first carry out a test application to a small area. If this dries to a
glossy film, thin with one part of White Spirit to two parts of Truguard Stabilising Masonry Primer and then test again in another small area.
It is important to ensure that a non-glossy, dried, sealed surface is produced.

Application
Stir well before use. Do not thin, except for absorbent surfaces, when a small quantity of clean water may be added. Apply two full coats, allowing 4-6 hours between coats under normal drying conditions. Do not apply when air or surface temperatures are below 10øC, or when rain is imminent. Suitable for application by brush, roller, conventional and airless spray.

Cleaning
Remove as much product as possible from application equipment before cleaning. Clean equipment immediately after use with warm soapy water and rinse thoroughly. Some local authorities have special facilities for disposal of waste coatings. Do not empty product into drains or watercourses. Replace lid firmly.

Warning
Keep out of reach of children.
Avoid contact with skin and eyes.
Do not ingest.
Do not breathe spray.
Wear respiratory protection.
If medical advice is needed have container
or label to hand.
Please refer to Product Label & Safety
Data Sheet (SDS) for hazard warnings and
information on safe handling/use/transport/
storage/disposal/emergency.
SDS available: www.leylandtrade.com or
call 01924 354354